The Aqua Flo CRO-800UX6 is a tankless reverse osmosis (RO) system. Most RO units fill a storage tank slowly and serve water from it; this one uses a high-capacity 800 GPD membrane and a built-in pump to make water on demand at about 0.62 gpm (2.3 L/min). Without a tank it takes much less room under the sink.
Two cartridges do the work. A 3-in-1 cartridge combines a sediment filter with carbon pre- and post-filters and the RO cartridge holds the membrane. The membrane reduces total dissolved solids, lead, cysts, asbestos, sulfates and cadmium and Aqua Flo lists PFOS among the contaminants reduced. Both are quick-change cartridges and indicator lights show when each is due.
The system runs at a 2:1 ratio of purified water to drain water. A leak detector shuts the system off and sounds an alarm if it senses water. It needs a nearby electrical outlet for the pump and comes with a chrome faucet, feed valve and installation kit.
Okanagan Aquatech installs the system and replaces the cartridges on schedule. It is designed for residential use on potable water.
Features
- No storage tank; water on demand
- 800 GPD membrane, 0.62 gpm flow
- 2:1 purified-to-drain ratio
- Leak detector with automatic shut-off and audible alarm
- Filter life indicator lights
- Two twist-out cartridges
- Chrome faucet and installation kit included
Specifications
| Model / item | CRO-800UX6 / 20010100 |
|---|---|
| Membrane rating | 800 GPD, thin film composite |
| Flow rate | 0.62 gpm (2.3 L/min) |
| Salt rejection | 93.6% or higher (varies with temperature and feed water) |
| Recovery | 65% (2 purified : 1 drain) |
| Stages | PP sediment, CB1 carbon pre-filter, RO membrane, CB2 carbon post-filter (PP, CB1 and CB2 combined in one 3-in-1 cartridge) |
| Feed water pressure | 30 to 70 psi (pressure reducing valve above 70 psi) |
| Feed water temperature | 4 to 38 °C (40 to 100 °F) |
| Feed water limits | TDS up to 2,500 ppm; hardness up to 7 gpg; iron up to 0.2 ppm; manganese up to 0.05 ppm; chlorine and chloramine up to 2.0 ppm; hydrogen sulfide 0; turbidity up to 1.0 NTU; pH 3.0 to 11.0 |
| Electrical | 100 to 240 V AC, 50/60 Hz input; 24 V DC 5 A output; 120 W |
| Sound level | 60 dB or less |
| Connections | 3/8 in quick connect inlet and faucet; 1/4 in quick connect drain |
| Dimensions (W x D x H) | 5.1 x 15.6 x 14.8 in |
| Use | Residential only |
Maintenance
Replace the 3-in-1 cartridge (65011215) every 6 to 12 months or 2,000 gallons and the RO cartridge (65011216) every 12 to 24 months or 3,200 gallons, per the Aqua Flo manual. Reset the filter life indicator after each change.
Replacement parts
- 65011215 Aqua Flo 3-in-1 sediment and carbon pre/post filter
- 65011216 Aqua Flo 800 GPD RO membrane cartridge




